18
Replacing the Oven Light
If the oven bulb needs replacing, it must comply with the
following specifications:
- Electric power: 25W,
- Electric rate: 230 V (50 Hz),
- Resistant to temperatures of 300°C,
- Connection type: E14.
These bulbs are available from your local Service Centre.
To replace the faulty bulb:
1. Ensure the oven is isolated from the electrical supply.
2. Turn the glass cover anticlockwise.
3. Remove the faulty bulb and replace with the new one.
4. Refit the glass cover.
5. Restore the electrical supply.
Cleaning the hinged grill
This model has been fitted with a hinged grill element to
enable you to clean the roof of the oven easily.
Before proceeding ensure the oven is
isolated from the electricity supply.
1) Undo the screw which holds the grill in place
2) Then gently pull the grill downward to allow access to
the oven roof
3) Clean the oven roof with a suitable cleaner and wipe dry
before replacing the hinged grill element.
4) Gently push up the grill element into place and firmly
screw into place the holding nut.
NOTE: Ensure the grill holding nut is
firmly in place to avoid the grill falling
down during operation.
FO 0287
Grease Filter
To prevent a build-up of fats on the fan impellor, the grease
filter must be fitted by clipping it over the vents in the back
panel.
To clean the grease filter
When the oven has cooled down, remove the filter by
pushing the protruding tongue on the filter upward, and
wash carefully.
The grease filter should be cleaned after every use. The
filter may be washed in a dishwasher on a 65°C wash. If
the filter is heavily soiled, place the filter in a saucepan of
water with approximately 1 teaspoon of automatic washing
powder or dishwasher powder. Bring to the boil and leave
to soak for approximately 30 minutes or longer depending
on the degree of soiling. Ensure the solution does not boil
over as it could mark your hob.
Rinse filter in clear water and dry.
Remember to refit the filter before using the oven again.
