Zanussi Electrolux   ZCM6650, Руководство пользователя

Страница: 16 / 21

71
Adaptation to different kinds of
gas
To adapt the appliance to a different kind of gas from the
one the appliance has been set for, follow the
instructions below in their order.
Gas connection (Fig. 14)
LPG : use the rubber pipe holder «C».
Natural gas : use the pipe fitting «A».
Always insert the gasket «B» (Fig. 14). Then proceed
with the gas connection, as indicated in the relevant
paragraphs.
Hob burners nozzles
replacement
- Remove the pan supports.
- Extract the caps and the wall baffles of the burners.
- Using a socket spanner 7 unscrew and remove (fig.
15) the nozzles replacing them with the ones required
for the kind of gas in use (see table).
Reassemble the parts following the same procedure
backwards.
These burners do not need any primary air regulation.
Hob burners - Adjustment of minimum level
To adjust the minimum level:
1) turn the knob to the position of minimum flame;
2) remove the knob (Fig. 16);
3a) in case of conversion from natural gas to LPG,
tightly screw the by-pass screw of the cocks;
3b) when converting from LPG to natural gas unscrew
about one-fourth turn by-pass screw, until a regular
small flame is reached.
Reassemble the parts following the same procedure
backards.
Check that, turning quickly the knob from the maximum
position to the minimum one, the flame does not go out.
Replacement of gas oven
burner nozzle
To replace the gas oven nozzle, follow this procedure:
a) remove the bottom of the oven;
b) undo screw 1 (fig. 17) and take the oven burner out;
c) with a socket spanner 7 unscrew and remove the
nozzle, situated in the bottom of the oven, and
replace it with the proper one (see Table);
d) reassemble the burner following the same procedu-
re backwards.
Minimum level adjustment
of gas oven burner
After setting the oven on maximum temperature with
closed door for about 10 minutes, turn the knob of the
thermostat on minimum.
To reach the thermostat by-pass screw and adjust the
minimum level, act as follows:
– take out the knobs;
– remove the front panel;
Fig. 16
FO 0068
Fig. 17
FO 1072
Fig. 18
FO 1061
– in case of conversion from natural gas to LPG, tightly
screw the by-pass screw of thermostat (fig. 18);
– converting from LPG to natural gas, unscrew the by-
pass screw, until a regular small flame is reached.
– finally check that turning quickly the tap from
maximum position to minimum position, the flame
does not go out;
– reassemble the front panel and the knobs.
The oven burner do not need any primary air regulation.