76
ENGLISH
Important!
The first time you use the washing machine, when
you switch it on, it may display a blinking zero and
give an audible warning signal. This is due to the fact
that the washing machine has performed a washing
cycle during the manufacturer’s inspection tests,
and this cycle has not been erased after its
completion.
• Delay start, a time value indicated in hours and
selected by means of the relevant button.
The delay time is displayed for 3 seconds, then the
duration of the selected programme reappears.
After you have pressed the START/PAUSE button,
the countdown begins, and the delay time value
decreases by one unit every hour.
You can delay the start of the selected programme
by up to 23 hours in one hour intervals.
• An incorrect option selection has been made:
this is indicated by the message Err when a
function incompatible with the current programme
is selected.
The incorrect selection is also indicated by an
audible warning signal.
• An alarm code indicates a fault in the machine
operation (see the relevant chapter on page 87).
E20
9 START/PAUSE button
This button has two functions:
• Start: after you have selected the desired
programme and options, press this button to start
the washing machine. The light above the button
will stop flashing and remain lit.
If you have selected a delay time by means of
button 11, the countdown will begin and will be
shown on the display.
• Pause: when you press this button again, the
programme in progress is interrupted. The light
above the button will start flashing. To restart the
programme, press the button again.
When you PAUSE the cycle, the DOOR LOCKED
light goes out, and it becomes possible to open
the door, provided
• the washing machine is not in the heating phase;
• the level of the water is not high;
• the drum is not turning.
Important! You must set the washing machine to
PAUSE before you make any change in the
programme in progress.
10 SPECIALS/ANNULL. button
(SKIP/RESET)
This button performs two functions:
- Clears the memory
- Selects special programmes
At the end of every programme the
SPECIALS/ANNULL. button must be pressed once
or repeatedly to clear the programme memory. This
will be confirmed by three dashes, flashing in the
display.
If the previous programme is not cleared, the display
will show a “
0
” flashing and an audible signal will
sound, when you switch the machine on.
Selecting a special programme:
A wash programme must be selected in the normal
way.
(
START button not pressed)
START/PAUSE
1329898690GB.qxd 04/05/2004 16:10 Pagina 76 (Nero/Process Black pellicola)