72
Normal power
Reduced power
NATURAL GAS
LPG
Mark
1/100
G20
20
mbar
G25
25
mbar
g/h
Mark
1/100
G 30
G 31
m
3
/h
kW
kW
Semi-rapid
Auxiliary
1
2
Natural gas:
3
LPG : 2,8
3
0,33
0,45
0,65
1,00
70
96
119
116
0,095
0,190
0,286
0,286
0,111
0,221
0,332
0,332
50
71
86
82
72,5
145
203
218
71,5
143
200
214
Rapid
Oven
BURNER
Burners charachteristics
Electrical connection
The unit is preset to work with a voltage of single phase
230 V.
Before making the connection make sure that:
the energy power available in the user's house is
sufficient for the normal supply of this appliance (see
rating plate).
the unit is correctly connected to earth through a
suitable plug and according to the installation country
Laws.
the socket or the omnipolar switch used for the
connection must be easilv reached with the installed
appliance.
The appliance is supplied without electric
plug
:
consequently, you have to install a plug fit for the load
shown in the serial number plate. The plug has to be
connected to an adequate socket.
If you wish to directly connect to the mains, you have to
interpose an omnipolar switch with a minimum opening
between contacts of 3 mm, between the unit and the
mains, complying with the existing regulations. The
brown live wire (originating from the clamp of the cooker
junction box) must always be connected to the phase
of the mains supply. In any case, the supply cord must
be positioned in such a way as it doesn't reach in any
point a temperature higher by 50°C than the room tem-
perature.
Should the supply cord need to be replaced, use only
the following cable types:
H05RR-F / H05VV-F / H05V2V2-F (T90). It is necessary
that the yellow/green earth wire is about 2cm longer than
the live and neutral ones (Fig. 19).
After the connection, test the heating elements for about
3 minutes to ensure that they are working correctly.
The manufacturer refuses any responsability in
cases where normal safety measures are not
observed.
Ground (yellow - green)
Neutral
wire
Phase
FO 0480
Fig. 19
