11
1.16. Digital outputs management
When you enter this section you can display the screen. The labels locate-
din correspondence of each output from the left represent: if they are in au-
tomatic “aut” or in manual “man”, the on/off logic (when they are in manual),
the present state. You can modify the state of each output by setting to
manual and then forcing to on or off; to do it from the initial screen identify
the output to be modifi ed by operating on the
keys through which you can switch
from one screen to the other. When the required output is identifi ed press the
and
keys until the exit
state to be modifi ed is highlighted and press the
key to switch it to manual. To modify its value switch to
the parameter on the side by pressing
and then
to force on or off. Press the
key to switch to the
previous screen.
1.17. Clock
confi guration
If you enter this section you can display the screen
ress the
key and then the
an
to modify the value of the
selected parameter: press again
to confi rm.
If you press the
key you will switch to the previous screen.
1.18. Maintenance
parameters
If you enter this section you can display the screen
In this screen you can set the maintenance thresholds and the maintenan-
ce codes which later will be shown at user level.
To programme the duration of a threshold press the
and
keys
until the required one is highlighted, then press
and then
and
to modify its values, press again
to confi rm. To modify
the code perform the same procedure once the required code has been
highlighted. If you press the
key you will switch to the previous screen.
1.19. Probe
parameters
In these masks confi gure some parameters which are represented in the table below:
P2P
OFF
Evaporator probe is provided
P3P
OFF
Condenser probe is provided
Csa
0
Environment probe adjustment
CF
°C
Unit of measurement °C/°F
The programming of these parameters is always performed like the others
1.20. Confi guration
If you enter this section you can display the screen
n this screen you can set
the duration of the retro-illumination
the contrast
the language
take into account that if the 201 value is set, the retro-illumination is
always on