ZANKER PVX1556, Руководство пользователя

Страница: 15 / 40

Troubleshooting
If the appliance does not start or it stops during
operation, before you contact an Authorised Service
Centre, check if you can solve the problem by yourself
with the help of the information in the table.
Warning! Repairs not properly done
may result in serious risk to the safety of
the user. Any repairs must be performed
by qualified personnel.
With some problems the end indicator flashes
intermittently indicating a malfunction.
The majority of problems that can occur can be
solved without the need to contact an Authorised
Service Centre.
Problem and alarm code Possible cause and solution
You cannot activate the appliance. • Make sure that the mains plug is connected to the mains
socket.
• Make sure that there is no damaged fuse in the fuse box.
The programme does not start. • Make sure that the appliance door is closed.
• If the delay start is set, cancel the setting or wait for the end
of the countdown.
• The appliance has started the procedure to recharge the res-
in inside the water softener. The duration of the procedure is
approximately 5 minutes.
The appliance does not fill with water.
•
The end indicator flashes 1 time intermittent-
ly.
• Acoustic signal sounds 1 time intermittently.
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is not too
low. For this information, contact your local water authority.
• Make sure that the water tap is not clogged.
• Make sure that the filter in the inlet hose is not clogged.
• Make sure that the inlet hose has no kinks or bends.
The appliance does not drain the water.
•
The end indicator flashes 2 times intermit-
tently.
• Acoustic signal sounds 2 times intermittently.
• Make sure that the sink spigot is not clogged.
• Make sure that the drain hose has no kinks or bends.
The anti-flood device is on.
•
The end indicator flashes 3 times intermit-
tently.
• Acoustic signal sounds 3 times intermittently.
• Close the water tap and contact an Authorised Service Cen-
tre.
The appliance stops and starts more times during
operation.
• It is normal. It provides optimal cleaning results and energy
savings.
The program lasts too long.
• If the delayed start option is set, cancel the delay setting or
wait for the end of the countdown.
Small leak from the appliance door. • The appliance is not levelled. Loosen or tighten the adjusta-
ble feet (if applicable).
• The appliance door is not centred on the tub. Adjust the rear
foot (if applicable).
15