ZANKER KDV10031FA, Руководство пользователя

Страница: 33 / 48

B A C
A. Previous button
B. OK button
C. Next button
Use Previous and Next to switch between the basic
settings and to change their value.
Use OK to enter the selected setting and to confirm
changing its value.
How to change a setting
Make sure the appliance is in setting mode.
1. Press Previous or Next until the indicator
dedicated to the desired setting flashes.
The light related to indicates the current setting
value:
• For the settings with two values (on and off),
the light is either on (= the setting is on) or off
(= the setting is off).
• For the settings with multiple values (levels),
the light flashes. The number of flashes
indicates the current setting value (e.g. 5
f pause + 5 flashes... = level 5).
2. Press OK to enter the setting.
• The indicator related to the setting is on.
• The other indicators are off.
• The light related to
indicates the current
setting value.
3. Press Previous or Next to change the value.
4. Press OK to confirm the setting.
• The new setting is saved.
• The appliance returns to the setting selection.
5. Press and hold simultaneously 30min and ECO for
about 3 seconds to exit setting mode.
The appliance returns to the programme selection.
The saved settings remain valid until you change them
again.
Before first use
1. Make sure that the current level of the water
softener agrees with the hardness of the water
supply. If not, adjust the level of the water
softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Start the programme 30min to remove any
residuals from the manufacturing process. Do not
use detergent and do not put dishes in the baskets.
After starting the programme, the appliance recharges
the resin in the water softener for up to 5 minutes. The
washing phase starts only after this procedure is
complete. The procedure is repeated periodically.
The salt container
Caution! Use rough salt designed for
dishwashers only. Fine salt increases the
risk of corrosion.
The salt is used to recharge the resin in the water
softener and to assure good washing results in daily
use.
How to fill the salt container
1. Turn the cap of the salt container counterclockwise
and remove it.
2. Put 1 litre of water in the salt container (only for the
first time).
3. Fill the salt container with 1 kg of salt (until it is full).
4. Carefully shake the funnel by its handle to get the
last granules inside.
5. Remove the salt around the opening of the salt
container.
33