INSTALLING THE HARD DRIVE
CONNECTING THE RECORDER
INSTALLING AND CONNECTING THE CAMERAS
To install the hard drive:
- Disconnect the power supply cable from the recorder.
- Unscrew 5 screws at the bottom of the device - Fig. 1.
- Connect the SATA hard drive to the correct terminals (power supply, data transmission) - Fig. 2.
- Screw the hard drive to the recorded using the screws provided with the system and designated holes in the housing - Fig. 3.
- Screw the upper cover of the recorder.
- Connect a TV set or a monitor to the recorder via the HDMI or D-SUB socket, using the correct cable (outside the scope of delivery).
- Connect any available router with Internet access to the LAN socket using a network cable with RJ-45 connectors.
- Connect the power supply unit (12 V, 2 A) to the recorder.
The system includes 3 power supply units (2 smaller, 12 V/500 mA units for powering the cameras and 1 larger, 12 V/2000 mA
unit for powering the recorder)!
- Hang the camera using 3 expansion plugs and screws provided with the system - Fig. 4.
- To adjust the camera angle, loosen the screw at the bottom of the camera using the Allen key provided with the system (Fig. 5).
Next, adjust the two dimensions of the camera to set its position at the required angle. After adjusting the camera, tighten the locking
screw.
- To connect the camera, plug in the power supply (12 V/500 mA power supply unit). The culverts provided with the system should be
used for conducting cables through walls.
Fig.1
Fig.4
Fig.2
Fig.5
Fig.3
Power supply
Router
