CARE, MAINTENANCE & STORAGE
Clean the appliance after every use.
NEVER IMMERSE THE APPLIANCE INTO WATER OR WASH IT UNDER RUNNING WATER.
ONLY CLEAN THE UNIT WHEN IT IS NOT IN USE OR PLUGGED INTO A WALL OUTLET.
To Safely Disconnect the Towel Steamer:
1.
Switch off the timer knob by turning the control counterclockwise to the OFF (0) position.
2. Remove the plug from the wall outlet and allow the towel steamer to cool down before adding or removing
any parts. Do not pull the cable to unplug the unit.
3. With the towel steamer cooled, remove the condensate water in the condensation tray before cleaning the
steamer.
Cleaning the Towel Steamer:
• To avoid damaging the unit, do not use any cleaning agents such as soap, gasoline, thinner, alcohol, bleach,
polishing powder, metallic brush, nylon brush and steel scourer to clean any part of appliance.
•
Clean the steam basket, steam lid and condensation tray with water, wipe it with a soft dry cloth.
• Make sure all the accessories are dirt-free and properly dried before putting them aside for storage.
TIP:
For best performance and to increase the life of this steamer it is recommended to use pure (distilled or
filtered) to descale the steamer. After 2 – 3 months of application, the deposit of precipitate is normal. The
amount of precipitate depends on the hardness of the water. Regular descaling is essential to extend the
appliance’s service life.
OVERHEAT PROTECTION:
SAFETY AUTO SHUTOFF
How it Works:
•
The temperature controller in the unit will shut off if the temperature exceeds the operating temperature
and there is water in the main body. The temperature controller will return to normal once the unit cools
down.
• With no water in the main body, the temperature will increase rapidly. The temperature controller will shut
off the heating element when it exceeds the operating temperature.
• If the unit is damaged and receives excessive electric current, the overcurrent protection will disable the
temperature controller and the timer. The unit is non-functioning and must be returned to the manufacturer
for repair.
TROUBLESHOOTING
Issues
Possible Causes
Solutions
No steam is
observed.
1. The appliance is not
activated.
2. Empty water tank.
3. Protective measure to
delay steam generation.
1. Ensure the unit has power. Unplug and replug the
unit and rotate the control knob clockwise.
2. Fill the water tank.
3. Wait for steam to be generated.
This may take
10-15 minutes.
The timer knob does
not function.
1. The appliance is not
activated.
2. The timer is not set.
1. Power up the appliance.
2. Set the timer.
The power indicator
does not light up.
The appliance is not
activated.
Power up the appliance.
If the following problems are encountered, follow the instructions above.
If the problem persists, contact customer service at 800-468-4348, 714-892-9200
or email [email protected].
