When properly tensioned, the LRQ Dust Cover Shim should sit below the lid mounting ledge as
indicated and should still have a slight bend. The LRQ Dust Cover Shim should be low enough that it
does not contact the bottom of the LRQ Dust Cover Adapter Lid when installed, but it should not be
so tight that it increases the drag of the stage.
Drive the LRQ stage back and forth through its full length a few times, and visually inspect that the
Dust Cover Shim does not bulge anywhere during travel. If the shim bulges, loosen and then re-
torque the M3x3 screw nearest the bulge in order to remove it. If loosening both screws on an end,
you may need to push down on the shim inside the Stage Top Adapter again to add some tension.
Repeat this process until the Dust Cover Shim stays flush with the Sheet Metal Sides through the full
length of travel.
Take the LRQ Dust Cover Adapter Lid and place it in position on the Stage Top Adapter, ensuring
that the countersink holes are on the top. Take the M2x4 screws and hand tighten them into the
Stage Top Adapter.
Manual Control
Most X-Series motion control products have an integrated, depressible knob with 20 detents per
revolution, allowing devices to be controlled without the use of a computer. There are two manual
