15
CONFIDENTIAL
DOC-USR-0018-09
____________________________________________________________________________________
Z3 Technology, LLC
♦
100 N. 8th St. STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
6.5
Streaming RTP
Once you have UDP streaming running, it is relatively simple to change to RTP streaming. All that is
needed is a change of settings. To stream using RTP, do the following steps:
(17)
Click on “Stop Encoder” to stop the current encoding session.
(18)
Change “Output Interface” from “ASI+Ethernet (CBR)” to “Ethernet (VBR).” This is necessary
because RTP is a variable bit rate format and is not supported over ASI.
(19)
Change “Output Format” from “MPEG-2 TS” to “RTP” (Note: Do
not
select “MPEG-TS over RTP”).
(20)
Click “Start Encoder” to start the encoding session.
Once you finish, your settings should look something like the following:
Figure 13 Changes to Encoding Parameters for RTP Encode
(2) Change Output
Interface to
“Ethernet(VBR)”
(3) Change Format to
“RTP”
(1) Click “Stop Encoder”
If encoder was running
(4) Click “Start
Encoder”
