CONFIDENTIAL
Z3-DM8168-PCI-RPS V1.05.01c
___________________________________________________________________________________________
Z3 Technology, LLC
♦
100 N 8
th
ST, STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
14
5.5 Ensure your PC has a proper IP address
(8) To be able to communicate with the board, the PC that you are communicating from needs to have at
least the same first 2 parts of the IP address. For example, if the board has an IP address of
192.168.81.68, your PC would need to have an address of 192.168.x.y, where x.y is anything but 81.68
(and not conflicting with whatever is on your current network). Ensure that this is the case. If
necessary, use the “P” and “Q” options in the RPS menu to modify the address / network mask of the
board to conform to your network. Note that the first 2 parts being the same are based on a netmask
of 255.255.0.0. If netmask were 255.255.255.0, then the first 3 parts of the IP address would have to
be the same.
After you are done, make note of the address you set your PC to. This will be important in the
streaming step.
5.6 Run the Web Interface to configure encode
(9) In your PC, run a web browser (for best results, Z3 recommends FireFox or Chrome). In this browser,
type the IP address of the board noted in step (7) (for example, if the default value is used, it would
be http://192.168.81.68). After about 3 seconds, the Encoder Settings menu should come up:
Figure 5 Encoder Settings Screen (Top Half)
