CONFIDENTIAL
DOC-USR-0055-05
___________________________________________________________________________________________
Z3 Technology, LLC
♦
100 N 8
th
ST, STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
10
2.0
QUICK START GUIDE
2.1
If You Have Received a System from Z3 with the Software Preloaded
To start working with the encoder, you can skip to Section 7.0, “ RUNNING THE ENCODER,”
on page 20. This section describes how to quickly generate a UDP or RTP stream to VLC, how to change
bitrate dynamically, how to adjust the UDP TS rate, how to tune for latency, and how to use DHCP.
Section 8.0, on page 43 describes streaming using RTMP and using “Encode 1 to 3” mode. Section 9.0, “
RUNNING THE DECODER” on page 49 describes using the Decoder mode. If you have any questions about
any GUI parameters you can refer to Section 12.0, “ SUMMARY OF OPTIONS,” on page 59.
2.2
If You Already Have a System from Z3 and Need to Update the Firmware
You can update the firmware via the user interface by following the instructions in Section 10.1,
“Method 1: Updating the Image File” on page 52.
2.3
If You are Ready to Start Development
Details on how to untar and build the code can be found in Section 5.0, “ UNTARRING AND BUILDING
THE SAMPLE CODE”, on page 13. A brief overview of the code itself can be found in Section 6.0, “
CODE OVERVIEW”, on page 15. Details on how to set up your system to access the code you have built
can be found in Section 10.2, “ Method 2: Running Your Code through TFTP/NFS”, on page 54.
*Note:
Actual version numbers for your Z3 product may differ from those pictured in this document.
