CONFIDENTIAL
DOC-USR-0171-01
___________________________________________________________________________________________
Z3 Technology, LLC
♦
100 N 8
th
ST, STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
67
Output Setup
Output Format
RTP
UDP
TSRTP
RTMP
TSFILE
FILE
MPTS
Output format of encoded stream.
RTP requires an SDP file for the receiver or the
use of the RTSP URL (see Section 7.8, “ Streaming
RTP”, on page 27).
If UDP is selected, check the value of TS Rate to
confirm it is in line with expectation (see Section
7.10, “Adjusting the UDP TS Rate”, on page 31).
TSRTP sends TS over an RTP stream. In VLC,
typing “rtp://:{port #}” will successfully receive
this.
TSFILE will write audio and video to a TS file. If
this is selected, type the path/name of the file in
“Dest Address” (for example:
/media/sda1/example.ts to write to “example.ts”
on a drive connected to USB1)
FILE will write raw .h264 and raw .aac to 2
separate files. If this is selected, you should type
the path/name of the H.264 file in “Dest Address”
(for example: /media/sda1/example.h264). If
audio is enabled, a companion .aac file is then
created (for example, for “example.h264” a
companion file “example_0.aac” is created).
MPTS can be used to multiplex multiple channels
in 1 TS stream. The address of that TS stream is
specified in the “MPTS” tab.
Dest Address
192.168.x.y
(192.168.0.6)
The IP address that the encoder is streaming to.
Dest Port
0 – 9999 (
5004
)
The port that the encoder is streaming to.
Aux TS File Enable
(UDP Only)
True
False
For UDP streaming only. If UDP is being streamed,
this allows the same UDP stream to be saved to a
TS file. The name of the file is specified in “Aux
TS File Location.”
Aux TS File Location
/tmp/aux1.ts
Appears if “Aux TS File Enable” is set to “True.”
