- Bring the 4-in-1 sensor closer to your Z-Wave controller
- Press and release the Z-Wave button quickly several times once you put the controller in the inclusion
mode to ensure the command has gone through
- Put your controller in the EXCLUSION mode and press and release the Z-Wave button, then try adding it
to your network again
Z-WAVE EXCLUSION
1. Bring the 4-in-1 sensor as close to your Z-Wave gateway controller as possible
2. Put your Z-Wave controller in exclusion/unpairing mode
3. Press and release the Z-Wave button TWICE quickly
4. The device should disappear from your controller's device list.
The led indicator will flash 3 times when you take the batteries out and put them back in to indicate the
device has been successfully excluded.
Please repeat the process following all steps carefully if the led indicator blinks only once when you re-
insert the batteries.
WAKE-UP MODE
Use the Wake Up command to set wake-up interval for the sensor (from 10 minutes to 1 week) to report
back to the controller. You can also press and release the Z-Wave button once to wake up the device
manually.
FACTORY RESET
If your primary controller is missing or inoperable, you may need to reset the device to factory settings. To
complete the reset process manually, remove the back cover to trigger tamper switch. Press and release
the Z-Wave button 10 TIMES quickly (within 10 seconds).
NOTE: All previously recorded activity and custom settings will be erased from the device’s memory.
ASSOCIATION
Once the 4-in-1 sensor is added to your Z-Wave network, you are able to monitor the values reported by
the device on your computer or mobile device.
Certified Z-Wave products from different manufacturers and product categories can be a part of the same
Z-Wave network. Non-battery powered nodes can act as signal repeaters to other devices in the network
regardless of manufacturer or brand.
light sensor
Z-Wave button
