17
Deleting a group
Step
Setup Key
LED Indication Status
1
Press
in Advance
Setup
•
The
“
OK
＂
light turns
on
2
Select a group number
from 1 to 16 (1-8 or
1-8)
•
“
OK
＂
LED flashes
once and stays on
•
“
LED_A
＂
off
•
“
LED_B
＂
flashes
slowly
•
Delete a group
completed
Note1: This process will only remove the group devices/EPs from its
assigned group but will not exclude it from the network.
Note 2: The above steps are needed if Z-URC
TM
550EU to be a
secondary remote controller and the Group information mapping from
gateway / primary controller is unsuccessful.
Assign Association for Two Devices
The Z-URC
TM
550EU can be used to assign one device to
automatically interact directly with another device.
For example you can assign a door sensor (primary node) to turn on the
light switch (secondary node) when the door is opened.
Adding Device/End-point to an Association Group
Step
Setup Key
LED Indication Status
1
Press
in Advance
Setup
•
The
“
OK
＂
light turns
on
2
Press
•
“
OK
＂
LED flashes
once and stays on
•
“
LED_A
＂
flashes
slowly
3
Select a group number
from 1 to 16 (1-8 or
1-8)
•
“
OK
＂
LED flashes
once and stays on
•
“
LED_A
＂
off
•
“
LED_B
＂
flashes
slowly
