Version 0.1
8 June 2011
www.2myhome.eu
class: 0x72 COMMAND_CLASS_MANUFACTURER_SPECIFIC
The Manufacturer Specific Command Class is used to identify the manufacturer and device type of a device.
This information is used to identify and configure the device in the 2MyHome Graphical Web-interface.
class: 0x32 COMMAND_CLASS_METER
The Meter Command Class is used to request the value of a Z-Wave enabled electric, gas, water or other kind
of meter.
class: 0x8F COMMAND_CLASS_MULTI_CMD
The Multi Command Class can be used for sending multiple commands at the same time, increasing Z-Wave
network performance.
class: 0x8E COMMAND_CLASS_MULTI_CHANNEL_ASSOCIATION
The Association Command Class is used to configure devices to send notifications to the myGate. This
Command Class can be used for devices that consist of multiple sub-devices. See also the Multi Channel
Command Class.
class: 0x60 COMMAND_CLASS_MULTI_CHANNEL
The Multi Channel Command Class is used to support devices that consist of multiple sub-devices, for instance
a quad-socket power switch.
class: 0x73 COMMAND_CLASS_POWERLEVEL
The Powerlevel Command Class is used to check the connection quality between two Z–Wave devices.
class: 0x75 COMMAND_CLASS_PROTECTION
The Protection Command Class can be used to set a device in ‘protected mode’. Protected mode can be seen
as some kind of child-lock, disabling for example any buttons on the device.
class: 0x93 COMMAND_CLASS_SCREEN_ATTRIBUTES
The Screen Attributes Command Class is used to request information about a screens on other devices. This
information is used for correctly updating these screens using the Screen Meta Data Command Class.
class: 0x30 COMMAND_CLASS_SENSOR_BINARY
The Sensor Binary Command Class is used to obtain the state of sensors that support only two states. An
example can be a door sensor (Open/Closed).
class: 0x31 COMMAND_CLASS_SENSOR_MULTILEVEL
The Multilevel Sensor Command Class is used to obtain the state of a numerical sensor, for example a
temperature sensor.
class: 0x27 COMMAND_CLASS_SWITCH_ALL
The All Switch Command Class can be used to turn of multiple devices (even different types of devices) at
exactly the same time.
class: 0x25 COMMAND_CLASS_SWITCH_BINARY
The Binary Switch Command Class can be used to control devices that can be turned on or off (for example a
power switch).
