To minimize the risk of electric shock, the power plug of this module has a grounding pin
which only fits into a grounding 3-prong electrical outlet. Please call a qualified electrician to
replace the outlet if the plug does not fit into it. Do not attempt to change the plug in any way.
The appliance connected to this Z-Wave module must not exceed 900W incandescent, 200W
CFL/LED, ½ horsepower motor and 15A, 1800W resistive load.
SETUP
Step 1. Plug in the AC power plug of the appliance to the receptacle of PA-100
Step 2. Insert the PA-100's 3-pin plug into an AC outlet of your preferred location. In normal
operating mode, the LED on the front panel will be lit.
Step 3. Add (Include) the module into your network by a Z-Wave certified controller. Please
refer to your gateway or controller’s instructions manual for details. Normally, the sequence
is as follows:
1. Initiate software to add a new device on your controlling device
2. When the controller’s software is ready, single click the button on the front of PA-
