2
Z-Wave & Zigbee/Thread mPCIe Adaptor
.5 Trace antenna designs
Not applicable. The module has its own antenna, and doesn’t need a host’s printed board microstrip
trace antenna etc.
2.6 RF exposure considerations
The module must be installed in the host equipment such that at least 20mm is maintained between
theantenna and users’ body; and if RF exposure statement or module layout is changed, then the host
product manufacturer required to take responsibility of the module through a change in FCC ID or new
application. The FCC ID of the module cannot be used on the final product. In these circumstances,
the host manufacturer will be responsible for re-evaluating the end product (including the transmitter)
and obtaining a separate FCC authorization.
As long as the conditions above are met, further transmitter test will not be required. However, the
host manufacturer is still responsible for testing their end-product for any additional compliance
requirements required with this module installed (for example, digital device emissions, PC peripheral
requirements, etc.)
2.7 Antennas
Antenna Specification are as follows:
Antenna Type:External antennai
Antenna Gain(Peak):1.5 dBi (Provided by LAB)
This device is intended only for host manufacturers under the following conditions:
The transmitter module may not be co-located with any other transmitter or antenna;
The module shall be only used with the External antenna(s) that has been originally tested and
certified with this module. The antenna must be either permanently attached or employ a ‘unique’
antenna coupler.
.
6
