ZPrinter
®
650 Hardware Manual
Printer Maintenance
zcentral.zcorp.com
60
All Rights Reserved
10/21/08
4. Using a paper towel dampened with distilled water, wipe the top and bottom Rails to remove any pow-
der. Move the Carriage back and forth as needed to clean the entire length of both rails.
5. Dry both Rails thoroughly with a clean dry paper towel.
6. Using a fresh paper towel, wipe the Carriage to remove any powder.
7. Locate the Fast Axis oiling hole, located in the top of the Fast Axis near the left end.
8. Make sure there is no powder visible inside the hole or on top of the Fast Axis.
9. Lift up the hinged cap that covers the oiling hole.
10. Using the oil supplied in your Accessories Kit, place 5 drops of oil into the small reservoir. Do not over-
fill. Close the cap.
11. Slide the Carriage back and forth to distribute the oil evenly over the Rails.
12. Reset the Maintenance Counter in ZPrint.
6.2 Piston Screw Lubrication
Frequency:
When prompted to in ZPrint.
1. Remove the back cover panel of the printer.
2. Remove the side panel.
3. On the LCD display, select
BUILD CHAMBER > LOWER PLATFORM.
Hold the Control Knob down
and lower the Build Bed platform as far as you can to expose the entire length of the piston screw.
4. Assemble the grease gun that is part of your Accessories Kit according to the instructions found in the
document
09576 Grease Gun Loading Instructions
, which is supplied in the materials that were
shipped with the printer. You can also find these instructions on our Web site at
zcentral.zcorp.com
.
Number
Component
1
Oil Reservoir
2
Oil Reservoir Cap
