Spectrum Z™510 3D Printer Hardware Manual
Service Menu and Other Maintenance
www.3dpuser.com
46
10/2/07
All Rights Reserved
12. When purging is completed, return to the
Service
menu and select
Auto Alignment
.
13. The printer will print out an alignment pattern. The first several layers will be gray-based and then the
color alignment pattern is printed.
14. The last part of the color alignment pattern that is printed is a bulls-eye pattern for you to confirm that
all print heads are aligned. A good alignment will look like the example below where the color does not
overlap into the red circle. If the alignment is not good, try cleaning the sensor window again and re-
run the Auto Alignment. If the pattern still fails, call your local service provider.
Please Note:
You may wish to start a build while the print heads are aligning. To do so, click
Cancel
to close the
Auto Align
dialog. The part builds on top of the alignment pattern. If you choose to
begin a build before the alignment is finished, you will be unable to confirm the bulls-eye pattern for
proper print head alignment.
