11
• “Kill3Honk”:
Set to yes, this will disable the
honks
that sound when leaving the running vehicle with
the keys
(driver door only for now)
• “ParkCAM”:
Set to yes, this will automatically
turn on SurroundView and the front camera when front
ParkSense is triggered.
• “AutoFold”:
Set to ON, this will automatically
retract and extend the power folding mirrors (if equipped)
with ignition.
• “AmberDRL”:
This setting will override factory DRLs
with amber DRLs and marker/hood lights. Options include:
Day
(on with headlights off)
Night
(on with headlights on)
Both
(on full-time)
• AutoPark Kill
“
AP Kill
”
:
Set to yes, this will
automatically disable the AutoPark feature when the
vehicle is turned on and foot is on the brake. For safety,
this will be disabled past 30mph and will reenable when
the vehicle is put in Park.
• “RemRestart”:
Set to ON, this will automatically
restart the vehicle once remote start times out after 15 minutes.
Pulse Brake Speed
“
PlsBrkSpd
”
:
Choose an
option to enable and set the third brake light pulse speed.
• Pulse Brake Number
“
PlsBrkNum
”
:
Set the
number of brake light flashes.
• Winch RPM
“
Winch XXXX
”
:
Select this option
with
◁
/BACK(HOLD) + CRUISE ON/OFF
then use
◁
/
BACK(HOLD) + /-
to adjust the Winch Mode
RPMs between 1300 and 2000. Use
◁
/BACK(HOLD) +
CRUISE ON/OFF
to save the setting.
Non-Menu Live Functions
Some
live
functions of the Tazer DT are
not accessed via a menu
, but rather work
automatically or with
button presses
.
• Light Show Shortcuts:
The Tazer DT has two
button shortcuts to start Light Shows. Those are:
Keyfob:
Press
UNLOCK, UNLOCK, LOCK, UNLOCK
on the keyfob to start the first light show in
the sequence (depending on which show it’s
configured to start with). Pressing unlock again
will advance to the next enabled show.
Pressing
lock will turn off the light shows.
You may lock
the vehicle while the shows are on by pressing the
button on the door handle or using the key.
Adaptive Cruise buttons:
See the button remap
instructions below. Press the remapped button to
turn the Light Show on or off.
The light show will shut off if it’s used for such a long
time that the vehicle battery voltage drops below 11V.
• Drive Mode Memory:
The Tazer DT will
automatically remember your drive mode setting and
activate it when you start the vehicle.
• Cooldown Mode:
Press
▷
+ CRUISE CANCEL
to
turn the engine fans on High.
Press again to turn them off.
NOTE:
When the engine is off, the fans will turn off
automatically if the battery drops to 11V.
NOTE:
The transmission temperature will read as 229F
while this mode is being used with the engine running.
NOTE:
Only works with the engine OFF on manual trucks
• Winch Mode:
Press
◁
/BACK(HOLD) + CRUISE RES
to raise the idle RPMs to the value selected in the live menu
(default 2000). There may be a few-second delay before it
changes. Touching the accelerator will cancel Winch Mode.
• Line Lock:
While
in 2WD
and at a full stop, press
◁
/BACK(HOLD) +
buttons. Once the ABS
and Brake lights on the dash begin to flash, continue to
hold the buttons and pump the brake pedal twice firmly
and release. The truck will stay held using only the front
brakes while you press on the accelerator to do a burnout.
“LineLock” will be displayed in the cluster.
Continued...
