YZ Systems NJEX 7300L, Инструкция и руководство по эксплуатации, Страница: 48 / 126

YZ Systems, Inc. • 3101 Pollok Drive • Conroe, Texas • USA • 77303 • P: 936.788.5593 • F: 936.788.5720
Page 38
NJEX 7300L ver.09042003
SSSSS
ECTION ECTION ECTION ECTION ECTION
66666::::: P P
P P
P
R RR R ROGRAMMING OGRAMMING OGRAMMING OGRAMMING OGRAMMING FOR FOR FOR FOR FOR
P P
P P
P
R RR R ROPOR OPOR OPOR OPOR OPORTION TION TION TION TIONAL AL AL AL AL
-----
TTTTTO O O O O
-----TTTTT
IME IME IME IME IME
O O
O O
O
PERA PERA PERA PERA PERATION TION TION TION TION
Setting Operator Input Parameters,
Continued
MODBUS Parameters, Continued
. . No Comm Port is used for Modbus;
ONLY Comm 2 is avaailable for Sentry4
1 . Comm 1 will be used for Modbus; and
Comm 2 is available for Sentry4.
1 2 Both Comm 1 & Comm 2 will be used for Modbus;
NO Comm is available for Sentry4.
Conclusion
This concludes programming the N-300 controller in
Proportional-to-Time Mode. If the NJEX 7300 System is
the only unit that will be initialized at this time the
following Section 7, Calibrating Signal Inputs will contain
the next appropriate information based on Proportional-
to-Time Mode operation.