GSM/CDMA/WCDMA VoIP Gateway
YX Technical department
~ 45 ~
Voice Volume is used to specify the input voice volume, output voice volume andDTMF tone
volume. The acceptable value for volume is an integer no less than 10 and no greater than 40.
The Dial Tone is sent to a customer or operator to indicate that the receiving end is ready to
receive dial pulses or DTMF signals. It is used in all types of d
ial offices when the customer’s or
operator’s dials produce dial pulses.
A Ring Back tone (or ringing tone) is an audible indication that is heard on the telephone line by
the caller while the phone they are calling is being rung. It is normally a repeated tone, designed to
assure the calling party that the called party's line is ringing.
The Busy Tone indicates that the called customer’s line has been reached but that it is busy,
being wrong, or on permanent signal. W hen an operator applies a busy signal, it is sometimes
called a busy-back tone. Line Busy Tone is a Low Tone that is on and off every 0.5 second.
The settings of Dial Tone, Ring Back Tone and Busy Tone depend on area. The default settings
for Asia are shown in the screenshot above for reference.
8.2 Network Debug
The screenshot below shows the auto ping settings
Fields are specified as following:
Auto Ping: Specify whether enable auto ping, when the device power on to runing.
IP Address: Specify the ip address.
