Page 6 of 9
PIAZZA PATIO HEATER
29/10/10
OPERATING
Lighting instructions
1.
Ensure that bottle is connected and
supply valve open (LPG).
2.
Press the control knob in and turn to
pilot setting.
3.
Continue to hold the control knob in (N.B. if the heater has been unused for
a period of time you may need to
allow up to one and a half minutes
for
air to purge from gas line). Slightly tilting the heater will assist the air to
purge.
4.
While still holding the control knob in, turn to “star” setting (an audible click
will be heard).
5.
The control knob must be held in at the “star” setting for a further 20
seconds to allow the flame failure device to engage.
6.
If the pilot has not ignited, repeat the procedure.
7.
Release the control knob (slowly) and turn to the flame setting required.
Changing a bottle (LPG).
When the flame turns abnormally yellow and becomes smaller it is time to change
the gas bottle. To do this simply slide the round cylinder cover up the main stem
to expose the gas cylinder.
Shut off gas supply at the gas bottle.
Remove the leg that is held on with a
wing nut. Disconnect regulator from the bottle and exchange bottles.
Dome Removal.
The reflective dome is designed to be easily removed so the Patio Heater can be
wheeled through doorways etc.
WARNING:
This should
only
be done after the heater has been off for a sufficient
enough time to
fully cool down
.
Abnormal performance.
If at any time the Patio Heater exhibits any problem or abnormal noise it should
be immediately turned off. The Patio heater should be checked and tested by
authorised service technician before being used.
