Page 5 of 12
Mezzo Hanging Patio Heater
29/10/10
Attach Channels:
Attach Vertical Channels to the Horizontal Assembly with M6 Bolts ensuring the channel
with the cable tie is bolted to the Arm with the cable tie.
Gas Piping.
Remove the two bolts from the holder clamp.
Place the Burner assembly in to holder of
Horizontal Assembly. Make and Bend up the gas pipe to neatly fit in to the channel.
Remove the Burner assembly and gas pipe.
Make the gas joint.
Bolt Assembly in to place:
Bolt Horizontal Assembly with Vertical Arms on to the Mounting Plates. Care is required to
not damage the vertical arms with the assembly hanging from one side only during this
process.
Electrical supply:
WARNING:
The controller uses voltages of shock hazard potential.
The Insulating box is supplied with Transformer mounted inside with a 2A fuse in a fuse
carrier.
The Insulating Box shall be positioned to allow future maintenance and access. Care is
required in removing the cut outs for the wire
Install the electrical wiring for the 240V supply to transformer and 24Volt system from the
24 volt side of the transformer to where the Connect Box will be mounted, positioning the
control switch and/or thermostat in required position.
24 Volt system, maximum length 50 metres (@ 1sq. mm).
Position Burner Assembly:
Position the burner assembly with Gas Pipe attached in to the Holder. Bolting tight with the
two bolts ensuring it is vertically positioned.
Electrical Connection:
Make the 24 volt supply connection within the connection box, position the grommet into
place. (Fig 3). Remove the Baffle from the vertical Channel where the cord will go.
Position the Connection Box in to the vertical channel and screw in place.
Run the cable down from the connection box ensuring the cable is held close to the
channel, using the cable ties to hold in place.
Replace the b
affle and screw in place
ensuring the cable is not touching the
baffle.
Fig 3