Page 4 of 12
Mezzo Hanging Patio Heater
29/10/10
Selection of Position
WARNING:
Yunca MEZZO Hanging Patio Heater is an unflued appliance, adequate
ventilation must always be provided. The Hanging Patio Heater has to be securely mounted
to a suitable beam or stand and be mounted away from the rain or any other moisture.
The heater should only be used when wind speeds are below 8km/h when heater is turned
down, or 16km/h when heater is on full.
The heater will effectively heat a radius of around 3m so its position should be chosen to
allow efficient use of heat.
Unpack and check that all parts are included. Refer to Table 1.
The following parts are NOT supplied:
M8 Bolts (x8) for attaching Mounting Plates to support
M8 Washers (x8) for attaching Mounting Plates to support
M8 Nuts (x8) for attaching Mounting Plates to support
Gas Pipe and fittings
Wire and fittings for the 240 volt supply
1mm Sq. wiring and fittings from the Transformer to the connection box at the vertical
channel. (24 volt side). Maximum length of 50 metres.
Bolting Holes:
Selection of the position to support the Yunca MEZZO Hanging Patio that offers a solid
base to bolt the Mounting plates too and be ideally 3.3 to 3.8 metres from the ground.
It is recommended to bolt the mounting plate in to position.
Mark out and drill suitable clearance holes for M8 Bolts. See Fig 2
Fig 2
Attach Mounting Plate:
Bolt Mounting plates in to place as shown in Fig 2
