33
Using the Remote Control
Pairing your YOYOCam with a Remote Control
Before use, each Remote must be paired with your YOYOCam. Up to five remotes can be paired; two
are supplied.
To pair a Remote Control with YOYOCam:
1.
Press the SET button. YOYOCam bleeps and LED flashes orange
indicating pairing
mode.
2.
Press any button on the remote control. YOYOCam bleeps and LED turns green
for 2
seconds then returns to orange flashing
ready to pair another remote control.
3.
Press SET to exit pairing mode. In any case pairing mode times out after 15 seconds.
Note:
If the battery in the remote control is low, YOYOCam emits three bleeps and exits learning
mode. Replace the battery in the remote control and try again.
To un-pair all Remote Controls:
Command:
#111#
Response:
All remote controls have been deleted
Arming and Disarming YOYOCam
Press
to arm YOYOCam. The Status indicator shows
when armed.
Press
to disarm YOYOCam. The Status indicator shows
when disarmed.
Emergency Button
When the Emergency button
is pressed, YOYOCam acknowledges with a bleep. By default,
YOYOCam calls the Master number. When the Master answers, the audio from YOYOCam can be
heard. If the Master does not answer, YOYOCam will call twice more (total three attempts) before
giving up.
YOYOCam can be configured to call additional numbers, called Emergency Numbers. Alternatively,
YOYOCam can be set to send MMS instead of making voice calls.
Note:
YOYOCam responds to the Emergency button
in both Armed and Unarmed states. If
YOYOCam is busy, for example sending images, the ongoing operation is cancelled in order to action
