26
alarm by SMS only or SMS followed by MMS, according to the way the sensor is configured.
Adding Wireless Sensors
To add a Wireless Sensor
1.
Make sure the wireless sensor is powered on.
2.
Send the command to add the sensor to YOYOCam
Command:
#05#SensorDescription#
(SMS notification upon alarm)
Command:
#05#*SensorDescription#
(SMS and MMS notification upon alarm)
Example:
#05#*FrontDoor#
Note:
SensorDescription
is a textual name (up to 15 numbers and letters) that you choose to
identify the sensor. If no name is supplied, YOYOCam names the sensors 1, 2, 3…
3.
YOYOCam emits a bleep tone and the indicator flashes alternate red and green.
4.
YOYOCam sends a notification SMS:
YOYOCam is ready to connect a sensor. Please
activate the sensor now.
5.
Activate the sensor. For example, open the door if you are adding a door sensor.
Note:
You have approximately 60 seconds to activate the sensor before YOYOCam cancels
the add operation and reverts to normal state.
6.
When YOYOCam receives the sensor activation signal, it will emit a bleep and sent a
notification message by SMS:
SensorDescription has been successfully loaded
7.
To exit sensor addition mode, press the SET key or wait approximately 60 seconds for the
mode to time out.
Error Responses
Sensor list is full. Please delete old
sensor first.
YOYOCam already has 15 sensors added.
Delete one first to create a space to add the new one.
YOYOCam bleeps repeatedly
Sensor is already added.
Indicator light flashes red/green for
approximately 60 seconds
Sensor has not been detected
Check that you correctly activated the sensor
Checking wireless sensors
To check which wireless sensors are present:
Command:
#07#
Response:
MMS message including sensor list
Deleting Wireless Sensors
To delete a wireless sensor:
Command:
#112#
SensorDescription
#
Example:
#112#FrontDoor#
Response:
Sensor deleted successfully FrontDoor
