If the weather station failed to receive transmission from remote sensor (“
- -
”display
on the LCD), press and hold
“
▼
” button for 3 seconds to receive transmission manually.
the remote temperature will show an animation of the RF antenna symbol
，
the Base
Station will re receive the wireless signal of the remote sensor.
F.Y.I.
when the wireless sensor set up different channels, the weather station "REMOTE
SENSOR" also want to switch to the same channel.
When there is no wireless sensor
signal transmission on the channel, "--" will be displayed in the channel of the weather
station
When the wireless remote sensor has no channel selection function, the sensor
defaults to channel 1.
Maximum/Minimum Temperature/Relative Humidity:
To toggle indoor/ remote maximum, minimum temperature and humidity data, press
the “
MEM
” button:
Once to show the maximum temperature and humidity values.
Twice to sow the minimum temperature and humidity values
Three times to return to the current temperature and humidity levels
To reset the maximum and minimum temperature and humidity, press and hold
down the “MEM” button about 2 seconds. This will reset all minimum and maximum
data recorded to the current displayed values.
F.Y.I.:
If the temperature reading is below ranges, the
LL.L
will be displayed. If the
temperature reading is above ranges, the
HH.H
will be displayed.
Remote Temperature alert setting
Press and hold down the “ ” button for 2 seconds until the icon for the Temperature
Alert” starts to flash
The icon of Upper limit of the Temperature alarm starts to flash. Use the “
▲
” and
“
“
▼
” buttons to set the required maximum temperature. Press “ ” to confirm your
setting.
The icon of the Lower limit of the Temperature alarm starts to flash. Use the “
▲
” and
“
▼
” buttons to set the required minimum temperature. Press “ ” button to confirm
your setting and to end the setting procedure
F.Y.I.:
