6
Mounting guideline
1 . Install the sensor at least 1 .5m off the ground for better
and more accurate wind measurements .
2 . Choose an open area within 150 meters from the main
console .
3 . Install the sensor as level as possible to achieve
accurate rain and wind measurements . Use the level
indicator on the sensor to ensure a level installation .
4 . Mount the sensor with the wind meter end pointing to
North to correctly orient the direction of the wind vane .
MAIN CONSOLE
Backup battery installation
1 . Remove the battery door of the main console .
2 . Insert 3 new AAA batteries .
3 . Close the battery door .
Powering up the console
1 . Plug the adaptor into the DC jack .
2 . Press
[ RESET ]
key to re-start the console .
3 . After reset, all LCD segments will show . The console will enter AP (access point) mode and
the status LED will turn on green .
The Console status LED can show the following status:
Status
LED status
AP mode for setup
Flash green light
Connected to Wi-fi router
Blue light
Search the Wi-fi router and fail connection
Flash blue light
Firmware update
Flash red light
Manual sensor pairing mode by pressing
[ Wi-fi / SENSOR ]
key
Flash cyan light
Refresh the upload data and sync internet time by press
[ Refresh ]
key
Flash purple
Mounting pole
and stand are
not included
