Youngman BoSS X3X-SP, Инструкция по эксплуатации, Страница: 43 / 48

41 youngmangroup.com
6.5 DAIly checks – oPerAtor checklIst
Prior to operating the platform, the following items
must be checked -
Machine number
check ok?
Hydraulic oil leaks by visual inspection of
the floor around the base unit, by feeling
underneath the drawer which houses the
power pack and by examination of the
ram and pressure loss valve and sensor
Loose electrical fittings and sensors by
visual inspection
Chafed hydraulic hose or electrical cables
by visual inspection
Condition of drive wheel and swivel castor
tyres and wheels by visual inspection
Structure – guardrails, platform, scissors
and chassis (eg damage, cracks,
corrosion, abrasions, welds, connections)
Visual inspection of the tab locking nuts
and washers on the scissor assembly
Obscured, dirty or damaged instruction
labelling and plates
Emergency stop function activated on the
handset controller
Emergency stop function activated on the
base unit
Emergency lowering of platform – both
backup power and manual systems (see
page 23)
Raise and lower functions including
descent delay and deployment of pothole
protection bars at each side of the base
unit (the raise and lower functions can
be tested by unclipping and removing
the handset controller from its holder on
the work platform and using the controls
whilst at ground level)
With the base unit key selector in the
platform position try to push the machine
to ensure the drive wheel brakes are
engaged
Switch on power and:
- Ensure that the horn sounds to confirm
- Check that the battery is fully charged
WARNING
Should any defects be identified in any of the
above areas, these should be reported to your
employer. It may be necessary to seek further
assistance from the supplier of the machine, this
may be the hire company or the manufacturer.
You should only rectify any defects if you are
authorised and competent to do so.
Do not use this machine unless each of the
items above is checked and stated as OK
using either the battery level indicator on
the front of the handset controller or by
checking the base unit LCD display
operation
·
·
·
·
·
·
·
·
·
·
·
·
·