Youngman BoSS X3X-SP, Инструкция по эксплуатации

Страница: 24 / 48

22 BoSS X3X-SP Instructions for Use
4.6 BAse unIt control PAnel
The base unit control panel is equipped with the
following features as shown on the photograph
below:
1. LCD DISPLAY AND DIAGNOSTIC CENTRE –
this display module is primarily used to make
adjustments to and to recalibrate the machine –
please see BoSS X3X-SP Maintenance
Manual for further information. The default
display shows the hour meter on the left
(hours the power pack and drive wheel
motors have been run for) and on the right,
the charge level of the batteries expressed as
a percentage. If a charging cable is plugged in
the display will read CHARGING.
2.
EMERGENCY STOP – in the event of an
emergency push the button. After the
emergency situation has passed twist to
release.
3.
PLATFORM/OFF/BASE – this key selector
isolates the power to the machine when the
key is in the OFF position and should be
removed for security and safety reasons when
the machine is not in use. The key can be
turned to the PLATFORM position to activate
the functions on the handset controller or
turned (spring loaded) to the
BASE position
to allow the platform to be raised and lowered
using the and buttons.
4.
– raises the platform when used in
conjunction with key switch held in the
BASE position.
5. – lowers the platform when used in
conjunction with key switch held in the
BASE position.
6. BATTERY CHARGER INDICATOR – LED light
will be lit red when the charging cable is
plugged into the machine and connected to a
mains/transformer power supply. The light will
turn green when the machine is fully charged.
7.
CHARGING CABLE SOCKET
– the charging
cables, which can be found in the tool box, are
plugged in here – either mains or 110V
transformer and then plugged into the power
supply.
DO NOT open the base unit drawers
during the charging process.
1 2
3 5 7
4 6