Youngman BoSS X3X-SP, Инструкция по эксплуатации

Страница: 14 / 48

12 BoSS X3X-SP Instructions for Use
2.2 oPerAtIng sIte
When a BoSS X3X-SP is delivered to site ensure
that the machine will be able to reach the work
area; this is not rough terrain machine and should
not be transported across unstable or uneven
ground as this could cause significant damage to
the machine. It is good practice to walk the route
from the machines parking place to the workplace.
A visual inspection of the operating area should
be made before using the machine paying
particular attention to the following issues:
2.2.1 grounD conDItIons
Ensure that the ground on which the
BoSS X3X-SP is to operate is capable of
supporting the weight of the machine (including
the maximum rated load of 150kg). Be aware of
specific floor areas such as manhole covers which
may not be designed to withstand the maximum
point loading of 14.83kg/cm
2
exerted by the
wheels.
2.2.2 grounD flAtness
Ideally the BoSS X3X-SP should be operated
on flat surfaces resulting in a 0 degree chassis
inclination. However, the BoSS X3X-SP can be
safely operated where the ground is slightly
uneven resulting in a 1.5˚ maximum lateral
and longitudinal inclination. The BoSS X3X-SP
operating system is fitted with a tilt sensor and will
not raise or drive if this angle is exceeded.
All four wheels must be in contact with the ground
at all times.
2.2.3 overheAD oBstructIons
Ensure that adequate clearance is available
above and all round the platform before
deployment and elevation and pay particular
attention to the presence of live electrical cables.
2.2.4 segregAtIon froM other sIte
vehIcle MoveMents
Every worksite should be subject to a risk
assessment and where vehicle movements are
likely to occur close to the BoSS X3X-SP, measures
should be taken to segregate the machine from
other vehicles. This might include the use of
cones, barriers, signage and re-routing measures.
WARNING
When the machine is being
operated in an area where there
are other vehicle movements
the operator should wear a
harness and the lanyard should
be clipped into the lanyard point
on the floor of the platform as
shown.