14) Assemble L1, L12, L13, L14, L15.
L1 - Colour code inductor
Now, wind the coils :
Use 0.42 emaneled wire supplied in the kit. The emanel of 0.42 wire is a kind of solder aid.
You don't have to scrape the emanel. Tin the leads directly. The emanel melts when
heated. However, if the temperature is not high enough, the emanel does not melt. It is
more reliable to remove the emanel with a knife and then tin. Never use fire to "burn" the
wire to remove the emanel.
L12, L13 - 40m LPF inductors. 17 turns, 0.42 wire on T37-2 core, leaving 1 cm for the
leads. A length of 22cm is enogh. Tin the leads, and then solder them to the related pads.
L14, L15 - 20m LPF inductors. 12 turns, 0.42 wire on T37-2 core, leaving 1 cm for the
leads. A length of 16cm is enogh. Tin the leads, and then solder them to the related pads.
15) Assemble RFC4 and RFC5 (the RFC ring cores are not supplied).
RFC 4 - 56 ohm resistor.
RFC 5 - TDK miniature inductor.
Содержание TJ2B
