YORKVILLE M1610, Руководство пользователя

Страница: 9 / 30

7
2 Main Functions for the Graphic EQ and Shelving Equalizers
i. To adjust the system to help reduce feedback, a normal technique is to turn the
main system up to the point of feedback and then adjust the EQ sliders individual-
ly to determine which frequency band will reduce the potential of feedback. When
the specific frequency band is isolated, set it to about -3 to -5 dB. Usually only 2
or 3 bands can be reduced before the feedback reduction process begins to affect
the sound quality.
ii. To adjust for deficiencies in the speaker system’s high frequency and bass response,
the M810/M1610 also has a 2-band rotary shelving equalizer. These work in conjunc-
tion with the 9-band graphic. Yorkville engineers have developed this technique to
provide you with greater tone shaping capability. This allows the graphic equalizer
bands frequencies to be spaced at closer intervals, which mean better selectivity for
feedback reduction and sound shaping. You may want to turn up the
Lo
and
Hi
con-
trols to give the system a more HiFi sound when you’re playing at lower volumes. At
higher volume levels, you may need to turn these controls down, this will help maxi-
mize the volume and tighten up the sound.
iii. The third use of the graphic equalizer is to adjust the sound character for artistic
reasons. The frequencies are adjusted until the sound feels best to the musicians.
M810/M1610 Rear Panel
1. Power Amplifiers
Each of the
M810/M1610
dual power amplifiers has two ¼-inch jacks and 1 Speakon
jack for speaker connections. The power amplifiers are designed to provide full power into
a 4-ohm load. Connecting two 4-ohm speakers (2-ohm load) to either
AMP A
or
AMP B
will not harm the
M810/M1610
but the maximum power output may be reduced.
WARNING:
Do not obstruct the flow of air around the vents on the rear of the
M810/M1610, this may cause the power amplifier to overheat. The amplifier will
start to reduce its power output in order to keep running. In extreme cases it may
be forced to shut down. If the clip LEDs are illuminated continuously and the Power
LED is off, this will indicate shutdown. After the M810/M1610 cools down, operation
will be restored automatically This condition should not occur if adequate ventila-
tion is provided at the back of the unit.
2. Power Switch and Breaker
The
Power
switch and circuit breaker are located on the rear panel. If the circuit breaker
trips during use, wait a few minutes (to cool), then push in to reset. The circuit breaker
can trip if the amplifier is too heavily loaded with long periods of continuous tones (such
as feedback). If the circuit breaker trips immediately after being reset, take the unit to
your Yorkville dealer for service.
CHANNEL
B
CHANNEL
A
SPEAKER OUTPUT SPEAKER OUTPUT
Phantom
Power
POWER
ON
Circuit
Breaker
DESIGNED & MANUFACTURED BY
Y ORKVILLE SOUND • TORONTO, CANADA
on
off
120VAC
60 Hz • 6.4 A
TYPE: YS1032
A-Z446A / 2.0
800 Watts MAX
@ 4 ohms
(2 ohm min.)
800 Watts MAX
@ 4 ohms
(2 ohm min.)
2 x 8 0 0 W a t t P o w e r e d M i x e r
S e r i e s 2
DISCONNECT POWER
BEFORE SERVICING!
DEBRANCHER L’APPEREIL
AVANT D’ENLEVER
LES COUVERCLES!
THIS UNIT MUST BE GROUNDED!
CET APPAREIL DOIT ETRE MIS Á TERRE!