3
6
6.. P
Prro
otte
ec
cttiio
on
n
The LS700P has circuitry to prevent clipping, over current and over excursion. The circuitry
does not alter the frequency response as the level changes. At high levels the limiter will
limit the gain of the LS700P and hence if the user attempts to set the subwoofer level
control at high levels the resulting setting will be incorrect. The level control should be set
while operating at low levels (under 10 watts). If the level control is set to high due to setting
it at high operating levels the input circuit will clip and the dynamics of the bass will be lost.
This can happen without audible distortion since the filters will filter out the distortion.
L
LS
S7
70
00
0P
P C
CO
ON
NF
FIIG
GU
UR
RA
AT
TIIO
ON
N E
EX
XA
AM
MP
PL
LE
ES
S
TWO SUBWOOFERS PER SYSTEM
LS700P
SUBWOOFER
LS700P
SUBWOOFER
POWER
AMPLIFIER
FULL–RANGE
SPEAKER
FULL–RANGE
SPEAKER
Right
Left
config02e-ls700p.eps
ONE SUBWOOFER, WITH MONO SYSTEM
LS700P
SUBWOOFER
POWER
AMPLIFIER
FULL–RANGE
SPEAKER/s
Output
config01e-ls700p.eps
ONE SUBWOOFER, WITH STEREO SYSTEM
LS700P
SUBWOOFER
POWER
AMPLIFIER
FULL–RANGE
SPEAKERS
Left
Right
Left
Right
config03e-ls700p.eps
ONE SUBWOOFER USING ÉLITE PROCESSOR
LS700P
SUBWOOFER
POWER
AMPLIFIER
élite
PROCESSOR
FULL–RANGE
SPEAKERS
Left
Right
R
L
INPUT
INPUT
AMP OUT
AMP IN
MID/
HI
SUB
OUT
SUB
OUT
MID/
HI
L
R
config04e-ls700p.eps
Note:
The LS700P built-in stand mounting adapter can be used with
Yorkville
SW-Teletube accessory to support our
E160
cabinets. The support tube can be adusted up to it’s full 5’4” extension safely as long as the LS700P is
not
inclined more than 10˚ (10 degrees).
WARNING:
Larger or heavier cabinets
should not be used!
