www.yorkfitness.com
www.yorkfitness.com
15
If you have a problem with your cross trainer, before you do anything else please check that all
the cables have been connected correctly. Loose cables are very common and many problems
can be solved by making sure the cables are properly connected.
The following table details the most common problems and how to fix them. If you still have a problem
after going through the troubleshooting guide please call your local YORK distributor for advice.
PROBLEM
CAUSE
CORRECTION
NO DISPLAY
No power
Make sure power cord is plugged in
properly
System halted
Unplug and re-plug the power cord to reset
the system
NO SPEED DISPLAY
Wires are damaged or not connected properly Verify all wires are connected properly
Speed sensor is too far from magnet
Contact your local YORK distributor
PARTIAL DISPLAY
The PA board is not connected properly
Unplug and re-plug the power cord
Verify all wires are connected properly
Disconnect and re-connect all cables
Contact your local YORK distributor
NO PULSE SIGNAL
Wires are damaged or not connected
properly
Verify all wires are connected properly
Too much hand movement
Dry palms
Palms too wet
Grip using moderate pressure
Hand Pulse Sensor is being gripped too tightly Remove all rings
User is wearing rings
Contact your local YORK distributor
ERROR CODE: E1
Indicate the console have not receive the body fat figure , Make sure the user have hold
onto the handgrip sensor ,Please do hold two hands together during training period.
ERROR CODE: E4
Indicate the user’s age, height, weight figure have exceed of the setting range when user
setting their information.
ERROR CODE: E5
Check the console together with the stage’s 12PIN connect cable, to see if the console
are bad contact or get loose with the stage’s 12PIN connect cable. Check the Motor
distance have exceed of the setting range or not.
FOR YOUR OWN SAFETY, DO NOT OPEN PROTECTIVE CASING. IF ERROR PERSIST,
PLEASE CONTACT YOUR LOCAL YORK DISTRIBUTOR FOR ADVICE. KEEP THE
EQUIPMENT OUT OF USE UNTIL IT IS REPAIRED.
If you are having problems with your heart rate reading, please note that some fibres used in
clothes eg) polyester, create static electricity that may prevent a reliable heart rate reading. Mobile
phones, TV’s, microwaves and other electrical appliances that generate an electromagnetic field
may also interfere with heart rate measurement.
Troubleshooting