8. Programming limit positions
10. Removing of the transmitter
5
1. The limit positions are set automatically after the first cycle.
Press
UP button.
Press and hold the programming
button on the motor
for 2 seconds.
LED diode flash once.
Motor will make
a short sound.
Press and hold STOP button
one the remote control.
LED diode will flash 5 times.
Motor will make a few short
sounds.
The transmitter has
been removed.
Press
DOWN button.
The motor will stop the curtain
and set the limit position.
The motor will stop the curtain
and set the limit position.
The limit positions
have been set.
METHOD 1:
Work motor direction has been
changed.
METHOD 2:
Changing the direction of work motor with this method delete the limit positions.
Press and hold the programming
button on the motor for 10 seconds. Release
programming button after the third flash
of the diode. Motor will make 3 sounds.
Press
DOWN button.
LED diode will flash 5 times.
Motor will make a sound.
Adding another transmitter is possible after programming the limit positions.
Press programming button P2
on the A remote control.
LED diode flash once.
Motor will make a sounds.
Press programming
button P2 on the
A remote control.
LED diode flash once.
Motor will make a sounds.
Press programming
button P2 on the
B remote control.
LED diode will flash 5 times.
Motor will make a few
short sound.
B transmitter
has been programmed.
METHOD 1:
METHOD 2:
Press and hold the programming
button on the motor
for 2 seconds.
LED diode flash once.
Motor will make a sound.
Press and hold STOP
button for 2 seconds on
the remote control.
LED diode will flash 5 times.
Motor will make a few short
sounds.
The transmitter has been
programmed.
9. Programming another transmitter
