6. Programming first transmitter
7. Changing motors direction
4
1. Longer than 10 seconds pause between series of button clicks during programming will cause device to switch off from
programming mode without saving any changes.
IV MODE - IMPULSE SWITCH
a) A short circuit between wires 1 and 3 causes to move the curtain in step-by-step mode.
METHOD 1:
Programming the first transmitter by this method it is possible, when none of the transmitters has been programmed.
METHOD 1:
Changing the work motor direction using this method is only possible before the limit positions are programmed.
METHOD 2:
If the limit positions have not been set, programming the first transmitter removes the previously programmed transmitters from
memory.
IV MODE
has been set.
Press and hold the programming button
on the motor for 10 seconds. Release
programming button after the third flash
of the diode. Motor will make 3 sounds.
Press P2
programming button
4 times.
LED diode will flash 4 times.
Motor will make 4 sounds.
Press and hold the programming
button on the motor for 2 seconds.
The LED diode will flash 5 times.
Motor will make 3 sounds.
Turn on
the power.
When power is on press and hold
programming button for 2 seconds.
Simultaneously
press and hold
UP and DOWN buttons
for 2 seconds.
LED diode will flash 5 times.
Motor will make few
short sounds.
LED diode flash once.
Motor will make a sound.
Press and hold STOP button for
2 seconds on the transmitter.
LED diode flashed.
Motor will make a sound.
Press and hold STOP button for
2 seconds on the transmitter.
LED diode will flash 5 times.
Motor will make few sounds.
LED diode will flash 5 times.
Motor will make few sounds.
The transmitter has been
programmed.
The transmitter has been
programmed.
The work motor direction
has been changed.
