YOODA 45 EZ/Y Series, Руководство пользователя

Страница: 4 / 6

4
6. Programming first transmitter
1. Longer than 4 seconds pause between series of button clicks during programming will cause device to switch off from
programming mode without saving any changes.
2. Programming the first transmitter removes the previously programmed transmitters from memory.
1. Longer than 4 seconds pause between series of button clicks will cause device to switch off from programming mode
without saving any changes.
2. To set the upper and lower limit position press the programming button P2 during the motor movement, it causes the
work displacement. Then you can precisely set the limit positions. Pressing the P2 button again motor will run continu -
ously.
Turn on power supply
or press programming
button on motors head
when power is on.
The roller
shutter will
make a longer
up/down
movement.
Press
programming
button P2.
Press
programming
button P2.
Press
UP button.
The roller shutter will make
a longer up/down
movement - transmitter
has been programmed.
The roller shutter will make
a longer up/down
movement.
The roller shutter will make
a longer up/down
movement.
Turn on power supply
or press programming
button on motors head
when power is on.
The roller
shutter will
make a longer
up/down
movement.
Press
programming
button P2.
Press
programming
button P2.
Press
DOWN button.
The roller shutter will make
a longer up/down
movement - motor has
changed its work direction.
The motor will make a
short up / down movement.
The roller shutter will make
a longer up/down
movement.
The roller shutter
will make a longer
up/down
movement.
Press
programming
button P2.
The roller shutter
will make a short
up/down
movement.
The roller shutter
will make a short
up/down
Press
UP button.
Press
programming
button P2.
Press
UP button.
7. Changing motors direction
8. Programming limit positions
METHOD 1:
Changing the work motor direction removes the previously programmed transmitters from the memory.
METHOD 2:
Changing the work motor direction does not change the limit positions.
Press and hold
programming button
for 5 seconds on
the motor head.
The motor will make short
up/down movement -
motor has changed its
work direction.
When the roller shutter
reaches upper limit position
press STOP button.