2-20
IM 701730-51E
2.5 Analyzing/Searching Data
• Setting the Level for Determining the Status (1 or 0) of the I/O Data
8.
Use jog shuttle & SELECT to select whether Data1 (CH2) is to be analyzed
(ON/OFF) (Data1 (CH2) box).
•
Data1 (CH2) will be analyzed when the mark to the left is highlighted.
•
When interleave mode is ON, you cannot set Data1 (CH2).
9.
Use jog shuttle & SELECT to set the level for determining whether the status of
Data1 (CH2) is 1 (Thr Upper box).
10.
Use jog shuttle & SELECT to set the level for determining whether the status of
Data1 (CH2) is 0 (Thr Lower box).
•
When the data exceeds the specified level (Thr Upper), it is determined to be 1.
•
When the data is below the specified level (Thr Lower), it is determined to be 0.
•
When the data is between the levels specified by Thr Upper and Thr Lower (including
the Thr Upper and Thr Lower values), it is determined to be indefinite data.
11.
Repeat steps 8 to 10 to set the level for determining the status of Data2 (CH3).
Select whether the data is to be analyzed (ON/OFF).
Set the level for determining whether the
data status is 1.
Set the level for determining whether the
data status is 0.
• Setting the Chip Select Signal (CS)
12.
Use jog shuttle & SELECT to select whether to make CH4 a CS signal (ON/
OFF) (each CH box).
CH4 is enabled as a CS signal when the mark to the left of CH4 is highlighted.
13.
Use jog shuttle & SELECT to set the level for determining the status of the CS
signal (CH level box on the right).
14.
Use jog shuttle & SELECT to select the enable status of the CS signal from H,
L, or X (Enable State box). I/O data is analyzed when the CS signal matches
the selected status.
If none of the CS signal is ON, the Enable State box displays “–”.
Set the level for determining the status of the CS
signal.
Select whether CH4 is to be a CS signal (ON/OFF).
Select the enable status of the CS signal from H,
L, and X.
