1-11
IM AQ1300-01EN
Features
3
2
1
4
5
6
7
8
9
10
11
12
13
14
15
16
App
Index
If the burst transmission interval determined by the value you set for Burst Number is greater than
the value you set for Interval, the AQ1300/AQ1301 will transmit frames at a constant rate without
any idle condition.
Tx Rate
When the Mode is Traffic Test or BERT
When Manual has been selected in the Test menu, you can set the Tx rate as a percentage or in
units of bits or fps. You can only set values that exceed 100% in units of bits. When Test Interface
is set to SFP(FE), you cannot set values that exceed 100%.
You can only set values as percentages when Auto or Auto(Remote) has been selected in the
Test menu.
Note
When the you set the Tx rate in bits, specify the number of bits in the IFG.
In QoS Test Mode
Regardless of the Test menu, you can only set the Tx rate as a percentage.
Tx Mode Settings
Continuous
In this mode, frames are transmitted continuously. After you start transmission, it continues until you
stop it.
Frames
In this mode, a specified number of frames is transmitted. After you start transmission, the specified
number of frames is sent, and then transmission is stopped automatically.
Tx Time
In this mode, frames are transmitted for a specified period of time. After you start transmission, it
continues for the specified period of time and is then stopped automatically.
1.6 Transmission Features
