7
IM 701946-01EN
Specifications
The specifications described in this section may vary depending on the type
of oscilloscope connected. The preconditions for the following specifications
are that the instrument should be warmed up for at least 20 minutes and the
environmental conditions should not exceed the specified limits of the probe.
Electrical Specifications
Attenuation Ratio
1
10 : 1 ±2% @DC
Voltage Coefficient
0.0025%/V (typical value)
System Bandwidth
500 MHz (–3 dB)
Probe Rise Time
< 700 ps (10% to 90%) (typical value)
Maximum Input Voltage
2
400 Vrms
1 This specification value is obtained when the probe is connected to an oscilloscope having an input
resistance of 1 MΩ ±1% and the input voltage is 100 V or less.
2 See the Compliant Standards shown below. See also “Voltage Derating.”
Electrical Characteristics
Input Resistance (system)
10 MΩ ±1%
Input Capacitance (system)
9.5 pF (typical value)
Input Impedance (system)
See also “Input Impedance.”
Compensation Range
10 pF to 25 pF (typical value)
Mechanical Characteristics
Weight (probe only)
Approximately 48 g
Cable Length
Approximately 1.2 m
Environmental Specifications
Altitude
Operating: Up to 2000 m
Storage:
Up to 15000 m
Temperature
Operating: 0 °C to 50 °C
Storage:
–40 °C to 71 °C
Maximum Relative Humidity
Operating: Relative humidity of 80% at a temperature
of up to 31 °C, decreasing linearly to relative
humidity of 40% at 50 °C if the temperature
is 31 °C or higher.
Compliant Standards
Safety Standards
EN 61010-031
Measurement Category “O”
1
400 Vrms, 1250 V transient
over-voltage
Measurement Category II
1
300 Vrms
Pollution Degree 2
2
Environmental Standards
3
EU RoHS Directive compliant
