Operation
¡
¡
¡
¡
¡
Normal Measurement
[Starting Normal Measurement]
q
Press MEASURE button to turn on the power supply. A laser
beam is emitted and the measurement starts. (In the Normal Mea-
surement mode, the unit takes measurements while MEASURE
button is pressed.)
w
Point the laser beam at a measuring object and aim it at the
center of the area to be measured. For the distance from this
thermometer to the measuring object, refer to page 9.
e
In the Normal Measurement mode, the measurement indication
"
" is shown on the LCD display and a laser indicator blinks.
[Quitting Normal Measurement / HOLD mode]
q
Release MEASURE button. Then, the laser beam turns off and
a value measured last is displayed for 15 seconds (HOLD mode).
The power supply turns off automatically after 15 seconds.
* NOR HOLD can be changed into MAX/MIN HOLD.
(See "Setting" on page 15)
¡
¡
¡
¡
¡
Continuous Measurement
[Starting Continuous Measurement]
q
Press and hold both of MEASURE button and SET/ENTER button simultaneously for two seconds or
more, then the Continuous Measurement mode switched on. (In the Continuous Measurement mode, the
thermometer keeps measuring temperatures without pressing MEASURE button.)
w
During the Continuous Measurement mode, LCD display shows
"
".
[Quitting Continuous Measurement]
q
To quit the Continuous Measurement mode, press and hold SET/ENTER button for two seconds or
more. Then, it switches to HOLD mode. The power supply turns off automatically after 15 seconds
in the HOLD mode.
CAUTION : The laser beam is constantly emitted during Continuous Measurement mode.
Be careful of it while operating the thermometer.
Set the battery supplied as an accessory and operate the unit according to the following procedure:
8
53008-E 12.5.12 1:12 PM ページ 7
