Yetti fish house, Руководство пользователя

Страница: 8 / 42

8
Couple the Yetti to the tow vehicle
If your Yetti does not have a jack, you will have to lift the coupler and place it over the ball.
If you have a jack, lower the Yetti tow tube until the coupler fully engages the hitch ball. If the coupler
does not line up with the hitch ball, adjust the position of the tow vehicle.
Engage the coupler locking mechanism. In the engaged position, the locking mechanism securely holds
the coupler to the hitch ball.
Insert a pin or lock through the hole in the locking mechanism.
Be sure the coupler is all the way on the hitch ball and the locking mechanism is engaged. A properly
engaged locking mechanism will allow the coupler to raise the rear of the tow vehicle. Using the Yetti
jack, test to see that you can raise the rear of the tow vehicle by 1 inch, after the coupler is locked to the
hitch
Lower the Yetti so that its entire tongue weight is held by the hitch, and continue retracting the jack to its
fully retracted position.
Uncoupling the Ball Hitch Yetti with Tongue Jack
Block tires to prevent rolling, before jacking the Yetti up.
Disconnect the electrical connector; safety chains; and unlock the coupler and open it
Before extending jack, make certain the ground surface below the jack pad will support the tongue load.
Slowly extend the jack and transfer the weight of the Yetti tongue to the jac
k.
Yetti Not Properly Coupled to the Hitch
It is critical that the Yetti be securely coupled to the hitch ball, and that the safety chains and emergency
break-away brake cable are correctly attached. Uncoupling may result in death or serious injury to you
and to others.
Overloading can damage the tongue jack. Do not use the tongue jack to raise the tow vehicle
more than one inch.
NOTICE
A loose hitch ball nut can result in uncoupling, leading to death or serious injury.
Be sure the hitch ball is tight to the hitch before coupling the trailer.
WARNING