Yetti fish house, Руководство пользователя

Страница: 29 / 42

29
Lowering Your Hydraulic Yetti
When lowering, it is recommended to use a surface that is as flat and level as possible. You may lower
your Yetti onto blocks to accomplish this. Increased pressure (side pressure) on the frame structure will
cause the safety pins to be difficult to remove. Side pressure can be caused by the use of tongue jacks;
uneven ground; and tow vehicle that are not in line with the Yetti
1) Turn on the wireless remote by pressing the red power button until both indicator lights flash.
a)
Green LED will flash rapidly when communication is established. The LED will blink slowly if the
receiver is off or there is no communication.
b)
The Red LED is for diagnostics and battery. The LED will blink once every second when the battery is
low and requires charging. It also blinks when there is a problem with the system in the form of an error
code. Refer to the Wireless Remote ERROR CODE CHART table for more information.
Note:
To check for low battery, turn the receiver off and leave the transmitter on. If the red LED continues
to blink, the battery is low and requires charging. If the red LED blinks only when the receiver is on, count
the number of blinks and refer to the ERROR CODE CHART tables for additional information.
Note:
Transmitters will stay on as long as the receiver is on, then turn off automatically ten minutes after
the receiver is turned off, in order to save power.
2) Starting at the tongue, remove the safety clip and pin. You may need to use the Tongue
Raise/Lower buttons to remove pressure from the pin. Unlock the coupler from the tow vehicle.
3)
Move to the driver’s (left) side wheel assembly. Remove the safety clip and pin. You may need to
use the Left Raise/Lower buttons to remove pressure from the pin.
4)
Move to passenger’s (right) side wheel assembly. Remove the safety clip and pin. You may need
to use the Right Raise/Lower buttons to remove pressure from the pin.
5) Press and hold the Lower All button until the Yetti is on the surface.
Raising Your Hydraulic Yetti
1) Turn on the wireless remote.
2) Press and hold the Raise All button until the Yetti is fully raised.
3) Start at
the driver’s (left) side wheel assembly. Insert the safety pin and clip. You may need to
use the Left Raise/Lower buttons to line up the holes to insert the pin.
4)
Move to the passenger’s (right) side wheel assembly. Insert the safety pin and clip. You may
need to use the Right Raise/Lower buttons to line up the holes to insert the pin.
5) Finish at the tongue, you may need to use the Tongue Raise/Lower Buttons to line up the holes
to insert the pin. Insert the safety pin and clip. Be sure the coupler is all the way on the hitch ball
and the locking mechanism is engaged.
6) After all safety pins and clips are installed, press and hold the Lower All button until the Yetti is
resting on the pins.
W
hen lowering or raising, make sure your hands and feet are not under the fish house !
WARNING
DANGER