Yetter 5000 SERIES, Руководство оператора

Страница: 8 / 24

8
ASSEMBLY INSTRUCTIONS
On some models, the hydraulic cylinder for adjusting the deck plate or stripper plate will need to be
relocated. Follow the steps below for relocating the cylinder. See the Devastator mount bracket
locations on pages 9
– 10 that match the model of your corn head to see if this applies to you.
Step 1:
Remove the hyd. cylinder’s hydraulic hoses & allow the hydraulic fluid to drain.
Step 2: Remove the hardware that is used to mount the hyd. cylinder and bracket to the corn head.
NOTE: Taking before photos will help with reassembly of hyd. cylinder & bracket to the corn head in its new location.
Step 3:
Relocate the hyd. cylinder & bracket to a location under a snout that does not get a Devastator mount bracket. Here is a
list where the cylinder should be located or be moved to: 4406 should be between 2-3, should
n’t need moved. 4408 (2018 – older)
should be between 3-4, should
n’t need moved. 4408 (2019 – newer) should be between 3-4, needs moved to between 4-5. 4408
folding should be between 3-4, needs moved to 4-5, 4412 rigid should be between 5-6,
shouldn’t need moved. 4412 folding should
be between 4-5, needs moved to 6-7.
Step 4: Add the hyd. hose extension, 2515-369, between the quick coupler and the existing hose. Some models of the corn head
may have hard, formed hoses that connect to the existing flexible hyd. hose & the extension needs installed between the hard,
formed hose & flexible hose.
AT QUICK COUPLER BETWEEN HARD, FORMED HOSE & FLEXIBLE HOSE
HYDRAULIC CYLINDER
FOR DECK PLATE
ADJUSTMENT
HAS BEEN RELOCATED