Yetter 5000 SERIES, Руководство оператора

Страница: 23 / 24

23
TROUBLSHOOTING
ISSUE CAUSE CORRECTIVE ACTION
Residue Plugging 1. Incorrect Head Angle
2. Roller Mount Tube incorrectly
installed
3. Pivot arm orientation incorrect
4. Bearing installed incorrectly
5. Intermeshing snapping rolls
6. Too much Spring Tension
1. Adjust head angle to 23
– 25 degrees (
see page 14)
2. Make sure the Bearing Support Tab is on the backside of
the Roller Mount Tube
3. Reposition the pivot arm so that it offsets under the snout &
not under the row
4. Make sure the side of the bearing that protrudes outside of
the cast housing is facing toward the roller (each roller
should spin freely by hand)
5. Order the 5000-080 Set Back Kit (order 2 per roller)
6. Back the nut off of the push rod until the nut is flush
Stalk aren’t
“devastated”
1. Insufficient spring down pressure
2. Operating corn head too high 1. Tighten push rod nut on spring bushing more
2. Lower corn head until the rollers engage
Corn Head won’t
fit on head cart
1. Devastators bottom out
2. Roller won’t clear cart tire
3. Header parking stand not
touching the head cart saddle 1. Adjust top rail & saddles higher on cart
2. Order 5000-082 Lift Kit
(raises roller 2”)
3. Slide the header parking stand down until contact with
head cart saddle is made.