Yetter 1310-001, Руководство оператора

Страница: 6 / 28

6
PRODUCT HANDLING…..
1. Close the feed gates.
FEED GATE LEVERS
SEED FLOW CONTROL
2. Load seed box onto frame and engage the lock down brackets. Ensure that the seed boxes are secure
before transporting.
3. Open seed box gate.
4. Start the engine.
5. Position the tube over the hopper, To raise the tube, open the ball valve on the hydraulic cylinder until the
tube reaches the desired height then close the ball valve.
6. Set the flow rate with the feed gates.
7. Move the toggle switch to control the start and stop of the seed flow.
CLEANOUT…
1. Close the seed box gate before the seeding implement is full, so that the Maximizer
belts are empty of seed before transporting.
2. Run the conveyor until all the seed that is on the belts has been transferred.
3. Close the feed gate.
TRANSPORTING…
1. Lower the tube.
2. Shut off fuel supply.
3. Run engine empty of fuel.
4. DO NOT operate machine on steep slopes.
5. Make sure all the lights and reflectors that are required by local highway authorities are in place, are clean and
can be seen clearly by all traffic.
6. Make sure the seed box gates and the feed gates are closed.
7. Make sure the seed boxes are securely seated and locked to the frame.
SERVICE…
1. Check engine oil level daily.
2. Change engine oil every 25 hours.
3. Check hydraulic oil levels regularly, level should be to the vent elbow fitting.
4. Check for oil leaks daily.
5. Grease bearings every 50 hours.
6. Clean hydraulic filter annually, replace if necessary.
7. Check bearings annually.
8. Inspect the hydraulic motor shaft couplers annually.
9. Check belt tension and adjust as required. Belt tension should be just enough to drive the belt. Belt will
require 10 hours of operation to break in. Some adjustment may be required at this time.
10. Belt and splice should be in good condition, check daily.